Troubleshooting - Wexiodisk WD-12 Installation And User Manual

Instructions for use

Troubleshooting

The following errors can be dealt with by the operator. If the problem persists,
contact authorised service personnel.
PROBLEM
The machine will not start.
The machine does not fill with
water.
The machine fills slowly.
The machine does not stop
filling.
The hood is not opened/
closed properly.
The machine does not start
washing.
Noise from the wash pump.
The machine stops in the
middle of the washing cycle
and starts taking in water.
The machine is not cleaning
properly.
The items are tipped over in
the baskets.
Items do not dry.
WD-12
CAUSE
The mains switch is off.
The incoming water stopcock is
closed.
The hood is open.
The level pipe is not in place.
The level pipe's rubber sleeve is
not sealing against the bottom
plate.
The rinsing pipe nozzles are
blocked.
The rinsing pipe nozzles are
blocked.
The level pipe is not in place.
The level pipe's rubber sleeve is
not sealing against the bottom
plate.
Air has got into the system.
The hood is open.
Dishes are blocking the magnet
on the hood.
Low water level. Foam in the
tank.
The level pipe's rubber sleeve is
not sealing against the bottom
plate.
The rinse and wash nozzles are
clogged with dirt.
There is too little detergent.
The water in the tank is too dirty.
Foam forming in tank.
Programme with too short a
washing time selected.
Dirt has dried on the items to be
washed.
The items are incorrectly posi-
tioned in the baskets.
The items are incorrectly posi-
tioned in the baskets.
Light items need washing.
The rinsing nozzles are blocked.
Too little rinsing agent.
The washed items have been left
in the machine.
46
ACTION
Turn on main switch
Open the stopcock.
Close the hood.
Fit the level pipe.
Adjust the level pipe. Check that the rubber
sleeve has not been damaged. Change the
rubber sleeve if it is damaged.
Clean the rinsing nozzles.
Clean the rinsing nozzles.
Fit the level pipe.
Adjust the level pipe. Check that the rubber
sleeve has not been damaged. Change the
rubber sleeve if it is damaged.
Bleed the hood lifting cylinder as per the
manual.
Close the hood.
Remove the dishes in question.
Check the level. Change the water.
Adjust the level pipe. Check that the rubber
sleeve has not been damaged. Change the
rubber sleeve if it is damaged.
Check and clean the nozzles.
Check the amount of detergent. The hose
must be submerged in liquid and the filter in
the hose must be clean.
Change the water.
Check that the washing temperature is not
too low and that the correct detergent is be-
ing used.
Choose a programme with a longer washing
time.
Soak the items before washing.
Use the correct type of washing basket and
accessories to ensure that the items are
correctly positioned.
Put the items in the correct position.
Use a net grid to hold the items.
Check and clean the nozzles.
Check the amount of rinsing agent. The
hose must be submerged in liquid and the
filter in the hose must be clean.
Remove the washed items once the pro-
gramme has ended.
Rev. 2.0 (201706)