Preparations Before Filling - Wexiodisk WD-6 DUPLUS Installation And User Manual

Operating instructions

4.1.2 Preparations before filling

Check and fit:
•
•
•
•
•
•
•
•
Remember:
•
•
•
•
•
•
WD-6 DUPLUS
That the dishwasher and all removable components have been cleaned. If
not – clean them!
That there is no dirt in the nozzles in the washing and rinsing arms (11, 22)
That all removable parts are in place, drain filter (17) (on machines with
drain pump only), level pipe (19), filter for recirculating rinse (20), tank filter
and cover plates (21).
That the rubber sleeve (18) must seal against the base plate
That the stopcock is open
The amount of detergent and drying agent
Check that the lower washing arm can rotate freely
That the power switch is in the ON position
Ordinary washing-up liquid must not be used in the machine or for soaking.
Contact your detergent supplier regarding the choice of a suitable
detergent. Washing-up liquid causes a build-up of foam, produces poor
wash results and can damage the machine.
Steel wool must not be used for pre-treating the dishware.
Only detergent and drying agent intended for industrial machines may be
used.
If using liquid detergent and drying agent, the same make and type of
detergent and drying agent should be used.
If the machine is designed for glass washing and equipped with a
condensing unit, detergent intended for aluminium should be used.
If the machine is equipped with a condensing unit, dishware should be
removed from the machine as soon as the condensation cycle is complete
so that re-condensation does not occur.
32
6D_funk1
Rev. 4.0 (202202)