Changing The Water - Wexiodisk WD-12 Installation And User Manual

Instructions for use

4.2.5 Changing the water

For the best washing results, it is important to change the water. For normally
soiled loads, the washing water should be changed after around 30 washes. Al-
ways change the water in the event of foam problems in the tank.
If IF09 appears on the display, this indicates that the water should be changed.
(option)
When the machine is in P0 mode with the hood open and the symbol (1) is lit,
change the water as follows:
Machines without a drain pump
•
•
•
•
•
•
•
•
Machines with a drain pump (option)
•
•
•
•
•
•
•
•
•
•
WD-12
Check that the machine is in P0 mode.
Open the hood (5).
Open the grid shelf (11) (option) and lock it in place with the clasp at the
back edge of the machine.
Remove the strainer baskets (18) and filter tray (19) and clean them.
Empty the machine by turning the level pipe (12) a quarter of a turn.
Once the tank is empty, turn the level pipe (12) clockwise, replace the
strainers (18) and return the grid shelf (11) (option) to its original position.
Check that the final rinse symbol (3) is lit.
Close the hood and the machine will refill.
Check that the machine is in P0 mode.
Open the hood (5).
Open the grid shelf (11) (option) and lock it in place with the clasp at the
back edge of the machine.
Remove the strainer baskets (18), filter tray (19) and the level pipe (12) and
clean them.
Press the 0/1 button (9).
Press P1 (6) to start the drain pump. "dP" appears on the display (2).
Once the tank is empty, replace the level pipe (12), strainer plates (19) and
the strainers (18). Return the grid shelf (11) (option) to its original position.
Press the 0/1 button (9).
Check that the final rinse symbol (3) is lit.
Close the hood and the machine will refill.
39
Rev. 2.0 (201706)