Table of Contents
Advertisement
Operating instructions
4.1.4 Preparations before filling
In this chapter, figures are given in brackets from the figure beneath chapter 4.1.1
Machine design.
Check:
•
•
•
•
•
•
•
Remember:
•
•
•
4.1.5 Filling and heating the machine
1.
2.
WD-40BRE
that the machine and removable parts have been cleaned. If not – clean
them!
that no dirt is in the wash arms' (10) or in the rinse pipes' (9, 11) nozzles.
that removable parts are correctly in place.
the amount of detergent and drying agent.
that the stopcock for the water to the machine is open.
that the main switch is in the ON position. When the main switch is set to
the ON position, it will take up to 25 seconds before the ON/OFF button (3)
illuminates blue and the machine switches to standby mode.
that an empty tray dispenser is in place (two dispensers if the machine is
fitted with a tray exchanger).
Ordinary washing-up liquid must not be used in the machine or for soaking.
Contact your detergent supplier regarding the choice of a suitable
detergent. Washing-up liquid causes a build-up of foam, produces poor
wash results and can damage the machine.
Only detergent and drying agent intended for industrial machines may be
used.
Use the same make and type of detergent and drying agent.
Start button
Activity text
28
Rev. (202303)
Advertisement
Table of Contents
