Electrical Connection; Water Connection, Regardless Of Any Options - Wexiodisk WD-12 Installation And User Manual

Installation

3.5.3 Electrical connection

The machine is designed for quick electrical installation.
This symbol on a machine part warns of electrical equipment. The machine must
be entirely non-live during service, turn off the power at the power switch and if
required, the switch should be locked to prevent unintentional operation. The
component may only be removed by a qualified electrician.
The machine's electronics are sensitive to electrostatic discharge (ESD), which is
why a static electricity wristband must be used when handling the electronics at
all times.
The machine must be connected to a lockable mains switch. This should be
placed on a wall, well-protected from water and from the steam which escapes
when the hood is opened. The machine is supplied with the electrical cable con-
nected (1).
Information on electrical connection is shown on the machine's wiring diagram.
These diagrams are located in the plastic file on the inside of the front panel. Store
them in the file provided after installation too.

3.5.4 Water connection, regardless of any options

A shut-off cock must be installed on the incoming lines
The water supply pipe is fitted with a break tank.
Connect the water pipe according to the marks by the connection point (2). For a
steam-heated dishwasher, connect the pipes for the steam (6) and condensation
water (7) as well. If the machine is connected to a hose, the internal diameter of
the hose must be at least 12 mm.
The required water flow and pressure can be found in the TECHNICAL SPECIFI-
CATIONS section.
WD-12
16
Rev. 2.0 (201706)