Installing Auxiliary Equipment - Wexiodisk WD-12 Installation And User Manual

Installation

3.4.3 Installing auxiliary equipment

Once the machine is in place and has been adjusted horizontally and vertically,
the auxiliary equipment can be fitted.
The machine can be positioned so that it can be straight-loaded or corner-loaded.
NB: When connecting sinks and conveyors, no holes must be drilled on the front
of the machine. If a hole does need to be drilled in the machine, the hole must be
fitted with an edge strip or similar protection.
A=Connection sink
B=Connection conveyor
The connection profile must look like the one shown in the drawing. The distance
of 6 mm may be reduced, but must not be less than 3 mm.
•
•
•
•
•
Use a spirit level to check that the sinks are horizontal and adjust the height, if
necessary.
A
A
50
304222
Attach the sink connection to the machine and then adjust.
Drill two ø 4.5 mm holes through the sink connection and the machine, ap-
prox. 100 mm from each outer edge.
Countersink the holes.
Seal with silicone between the connection and the machine.
Secure the sink with countersunk M4 screws, grommets on the outside sur-
face and nuts. Alternatively, you can secure the sink to the wall with wall
brackets.
WD-12
B
A
6
13
Rev. 2.0 (201706)
B
B
6