Table of Contents
Advertisement
Instructions for use
4.1.2 Preparations before filling
4.1.3 Filling and heating the machine
Check:
•
that the machine has been cleaned and that the stopcocks for the water are
open.
•
the amount of detergent and drying agent.
•
that the dispensers are in place.
NOTE: Ordinary washing-up liquid must not be used in the machine or for soak-
ing. It causes foam to form and produces poor washing results.
Fit:
•
outlet seals (29,30). The rubber sleeve (31) on the outlet seals must seal
against the bottom plate..
•
strainers (28, 33).
•
curtains (23)
•
The doors must be closed.
•
Press button (10) to switch on the power supply.
•
Press button (3). The filling and heating process will begin.
•
When the machine is filled and heated, it starts and runs for a while to mix
the detergent.
•
When the detergent is mixed, the message on the display indicates that the
feed should start. Start the conveyor belt by pressing button (5).
•
The machine is now ready to wash.
WD-59CT & WD-66CT
28
Rev. 2.0 (20110124)
Advertisement
Table of Contents
