Wexiodisk WD-12 Installation And User Manual page 30

Installation
1. Check:
•
•
•
•
•
•
2. Filling the machine:
•
•
•
•
3. Start the machine:
•
•
•
4. Check the setting of the reference values:
•
•
•
5. Run a number of washes complete with loads and check that:
•
•
•
•
•
6. Final check: Empty the machine and turn off the power using the mains
switch.
•
•
•
7. Train the dishwashing staff
•
•
•
WD-12
Water and drain connections
That the machine is evenly balanced
Detergent and drying agent
Filters, strainer plates and level pipe are in place
That the overheating protection device is reset
That bleeding of the booster pump has been carried out
Turn on the mains switch and any circuit breakers
Close the hood
Fill the machine with water as per the INSTRUCTIONS FOR USE
Bleed the hood cylinder as per the manual
Check the pumps' direction of rotation.
NOTE! If the direction of rotation is wrong, the phase must be inverted on
the lockable main switch
Empty the machine and refill it
Check the final rinse flow during filling
(All the reference values have been set to the recommended values on de-
livery.)
The delay for the booster pump
Check the temperatures
There are no water leaks
The automatic hood lift's anti-crushing system is working
The water temperatures are maintained
The washed items are clean
The washed items are dried
Note: The drying agent equipment is roughly set at the factory; contact your
detergent supplier for a more precise setting.
Re-tighten all connections on relays and any circuit breakers
Set all the circuit breakers to the on position
Display the maintenance instructions supplied with the machine
Washing
Care (daily, weekly and other frequencies)
Recommendation for yearly service
26
Rev. 2.0 (201706)