Siemens SINUMERIK 840C Installation Instructions Manual page 444

10.94
210
Default value
0000
Input of address for the variable which is significant for stopping the recording (see also
MD 206).
211
Default value
0000
Input of threshold (value) with which the contents of the variable specified in MD 210 are
compared in order to stop the recording (see also MD 206).
212
Default value
0C00
Input of address of recording signal 1 (see also MD 206).
213
Default value
0C04
Input of address of recording signal 2 (see also MD 206).
214
Default value
0000
Input of start for the output of the transient recorder function (see also MD 206).
The contents of the recorder memory are output via 2 DACs as soon as the above machine
data is set to 1H. The output is repeated cyclically.
215
Default value
0
Input of shift factor for signal 1 (see also MD 206). The top 8 bits from a 16-bit wide memory
location are output. This machine data specifies how often the value must be shifted to the left
beforehand.
©
Siemens AG 1992 All Rights Reserved
SINUMERIK 840C (IA)
Address for stop condition
Lower input limit Upper input limit
0000
Threshold for stop condition
Lower input limit Upper input limit
0000
Address for signal 1
Lower input limit Upper input limit
0000
Address for signal 2
Lower input limit Upper input limit
0000
Start output of recording
Lower input limit Upper input limit
0000
Shift factor signal 1
Lower input limit Upper input limit
0
6FC5197- AA50
7 Drive Machine Data (SIMODRIVE Drive MD)
7.1.2 MSD MD (data description - SW 3)
Units
FFFF Hex
Units
FFFF Hex
Units
FFFF Hex
Units
FFFF Hex
Units
0001 Hex
Units
15 –
Active
at once
Active
at once
Active
at once
Active
at once
Active
at once
Active
at once
7–29