Siemens SINUMERIK 840C Installation Instructions Manual page 458

12.93
281
Default value
0000
The filter type is selected in this machine data (see MD 280).
0: Bandstop characteristic
1: Low-pass characteristic
283
Default value
1 000
Input of lower adaptation speed for the speed controller. The speed controller machine data
can be adapted, i.e. the P gain and reset time altered as a function of speed, in gear stage 1.
The machine data from MD 265 and MD 266 are applied at speeds below the value specified
in this machine data (see diagram MD 203).
284
Default value
1 200
Input of upper adaptation speed for the speed controller. The speed controller machine data
can be adapted, i.e. the P gain and reset time altered as a function of speed, in gear stage 1.
The machine data from MD 285 and MD 288 are applied at speeds above the value specified
in this machine data (see diagram MD 203).
285
Default value
24.0
Input of P-gain for the upper adaptation speed. This machine data contains the P-gain at
speeds above the value entered in MD 284 (see diagram MD 203).
286
Default value
100
Input of P-gain reduction factor for the upper adaptation speed. This machine data contains the
multiplication factor for the P-gain characteristic (see diagram MD 203).
©
Siemens AG 1992 All Rights Reserved
SINUMERIK 840C (IA)
Type torque setpoint filter motor 2
Lower input limit
0000
Lower adaptation speed motor 2
Lower input limit
0 (max. speed) –2
Upper adaptation speed motor 2
Lower input limit
0
P-gain upper adaptation speed motor 2
Lower input limit
0
Reduction factor P-gain motor 2
Lower input limit
1
6FC5197- AA50
7 Drive Machine Data (SIMODRIVE Drive MD)
7.1.2 MSD MD (data description - SW 3)
Upper input limit
0001
Upper input limit
Upper input limit
max. speed
Upper input limit
120.0
Upper input limit
200
Active
at once
Units
Hex
Active
at once
Units
rev/min
Active
at once
Units
rev/min
Active
at once
Units
–
Active
at once
Units
%
7–43