09.95
You can select the SIEMENS Service 3 function with this vertical softkey.
SIEMENS
Service 3
Fig. 9.36
Physical addresses can be defined in this display. The toggle field "Module type"
has been extended to include "NCK" (from SW 5).
Siemens AG 2001 All Rights Reserved 6FC5197–jAA50
SINUMERIK 840C (IA)
9 Drive Servo Start-Up Application (as from SW 3)
The displayed signals are not explained here.
The SIEMENS Service 3 softkey function is relevant only
for SIEMENS servicing procedures and should be used
only after consultation via the hotline.
9.6.1 Selection of measured signal
9–67