Cycles Machine Data (As From Sw 3) - Siemens SINUMERIK 840C Installation Instructions Manual

09.95
5.5

Cycles machine data (as from SW 3)

Selection
Press the Diagnosis, Start-up, Machine data and Cycle MD softkeys to call up the
cycles machine data display.
Fig. 5.8
Explanation Measuring cycles and machining cycles are available for standard machining
routines that are repeated several times. The cycles can be assigned the
required machine data via the Cycles MD softkey. In this area you will find
central and channel-dependent cycle machine data. The Central cycles MD are
divided up into memory groups for measuring elements, measuring element data,
control bit, user data and user bits. The Channel-dependent cycles MD are
divided into values for measuring cycles, control bits for measuring cycles, user
data and user bits.
Note The functions of the individual machine data are described in the Installation
Guide, User Guide and Programming Guide for cycles.
Siemens AG 2001 All Rights Reserved 6FC5197–jAA50
SINUMERIK 840C (IA)
Machine
data
Cycles MD
5 Machine Data Dialog (MDD – as from SW 3)
5.5 Cycles machine data (as from SW 3)
Diagnosis
Start-up
5–27