Siemens SINUMERIK 840C Installation Instructions Manual page 596

8 PLC Machine Data (PLC MD)
8.2 PLC MD for the operating system (system data)
8
1)
Default value
1
9
1)
Default value
1
10
1)
Default value
3
These entries inform the PLC operating system of the numbers of the last channel, spindle
and axis.
See also PLC MD 6000, 6012 and 6016
Example:
PLC-MD 8 = 4, PLC MD 6000 = 0000 0111
Informs the PLC operating system that channels 1, 2 and 3 can be processed.
The PLC operating system processes DB10, DB11 and DB12 and transfers them to the NC-
PLC interface.
After each restart, the PLC system obtains the information required from the relevant NC
machine data and stores it in the data blocks DB60 and DB63, which means that
- the other PLC MD remain active
- the PLC processes only those channels, spindles and axes actually defined via NC MD
- any changes in the number of channels, spindles or axes will become effective only after a
PLC restart.
11
Default value
127
12
Default value
127
You can use this MD to specify the last input byte/output byte to be reset in the input
image/output image on a cold or warm restart. This means that the bytes not used by the
process peripherals can be utilized as additional retentive flag bytes.
_______
1) As from SW 3, these PLC MDs are irrelevant.
8–4
Last active channel
Lower input limit Upper input limit
1
Last active spindle
Lower input limit Upper input limit
1
Last active axis
Lower input limit Upper input limit
1
Last byte to reset in input image
Lower input limit Upper input limit
64
Last byte to reset in output image
Lower input limit Upper input limit
64
© Siemens AG 1992 All Rights Reserved
Units
4 –
Units
6 –
Units
30 –
Units
127 –
Units
127 –
6FC5197- AA50
SINUMERIK 840C (IA)
09.95
DB 60
DW 8
DB 60
DW 9
DB 60
DW 10
DB 60
DW 11
DB 60
DW 12