Siemens SINUMERIK 840C Installation Instructions Manual page 384

04.96
2508*-
D component comp. contr. 2nd - 8th par. set as from SW 4
2514*
Default value
0
These MD have the same meaning as MD 489*, see also "Functional Descriptions: Parameter
set switchover".
2515*-
Time constant parallel model 2nd - 8th par. set
2521*
Default value
6 000
These MD have the same meaning as MD 490*, see also "Functional Descriptions: Parameter
set switchover".
2522*-
Alarm limit speed as from SW 4 1st to 8th par. set
2529*
Default value
MD 403* ff.+10%
These machine data are active only with gear interpolation.
2530*-
Alarm limit acc. constant as from SW 4 1st to 8th par. set
2537*
Default value
MD 478* ff.+10%
These machine data are active only with gear interpolation.
2546*-
Tol. band synchr. "fine" 2nd - 8th par. set as from SW 4
2552*
Default value
40
These MD have the same meaning as MD 491*, see also "Functional Descriptions: Parameter
set switchover".
2553*-
Tol. band synchr. "coarse" 2nd - 8th par. set as from SW 4
2559*
Default value
100
These MD have the same meaning as MD 492*, see also "Functional Descriptions: Parameter
set switchover".
©
Siemens AG 1992 All Rights Reserved
SINUMERIK 840C (IA)
6 NC Machine Data (NC MD), NC Setting Data (NC SD)
Lower input limit Upper input limit
0
as from SW 4
Lower input limit Upper input limit
0
Lower input limit Upper input limit
0
Lower input limit Upper input limit
0
Lower input limit Upper input limit
0 99 999 999 (SW5.4
and higher)
Lower input limit Upper input limit
0 99 999 999 (SW5.4
and higher)
6FC5197- AA50
6.9 MDs for parameter set switchover
Units
16 000
Units
16 000 0.01 ms
Units
99 999 rpm/or 0.1 rpm
Units
50 000 ms
Units
16 000
1 unit (MS)
Units
16 000
1 unit (MS)
Active on
RESET
1
Active on
RESET
Active on
NC Stop
Active on
NC Stop
Active on
RESET
Active on
RESET
6–199