Siemens SINUMERIK 840C Installation Instructions Manual page 410

12.93
312*
Default value
0
The scale centre defines where the reference point for the alteration of the programmed axis
positions using the scale factor lies (see Programming Guide for detailed description).
The scale centre is programmed together with G51 in the block.
320*
Clamping torque for move against fixed stop
Default value
0
This SD is used to define the desired clamping torque as a % of the max. torque of the
component. Input in units of 0.1 %
©
Siemens AG 1992 All Rights Reserved
SINUMERIK 840C (IA)
6 NC Machine Data (NC MD), NC Setting Data (NC SD)
Scale centre NC
Lower input limit Upper input limit
– 99 999.999 + 99 999.999
Lower input limit Upper input limit
1
6FC5197- AA50
6.12.1 NC setting data (NC SD)
Units
mm or inches
Units
999 0.1 %
Active on
–
Active on
–
6–225