Siemens SINUMERIK 840C Installation Instructions Manual page 506

07.97
1115
Default value
0.0
Input of ohmic resistance of the armature winding (phase value) as specified on the motor data
sheet (non-Siemens motor) or automatic parameterization using machine data "Motor code
number" (MD 1102).
Note:
This data is relevant only for FDD drives.
1116
Default value
0.0
Input of armature rotating-field inductance as specified on the motor data sheet (non-Siemens
motor) or automatic parameterization using machine data "Motor code number" (MD 1102).
Note:
This data is relevant only for FDD drives.
1117
Default value
0.0
Input of motor moment of inertia as specified on the motor data sheet (non-Siemens motor) or
automatic parameterization using machine data "Motor code number" (MD 1102 - in motors
without a holding brake).
* Active on "Power On" until SW < 6
1118
Default value
0.0
Input of motor zero-speed current as specified on motor data sheet (non-Siemens motor) or
automatic parameterization using machine data "Motor code number" (MD 1102). The above
machine data corresponds to the thermally permissible continuous current at zero motor speed
with an overtemperature of 100 kelvin.
Note:
This data is relevant only for FDD drives.
©
Siemens AG 1992 All Rights Reserved
SINUMERIK 840C (IA)
Armature resistance
Lower input limit Upper input limit
0.0
Armature inductance
Lower input limit Upper input limit
0.0
Motor moment of inertia
Lower input limit Upper input limit
32.0 (SW 5 and
0.0
Motor zero-speed current
Lower input limit Upper input limit
0.0
6FC5197- AA50
7 Drive Machine Data (SIMODRIVE Drive MD)
7.3.2 Drive MD (data description)
Units
20.0
Units
100.0 mH
Units
kgm
higher)
Units
500.0
Active on
Power On
Active on
Power On
Active
at once*
2
Active on
Power On
A
7–91