Siemens SINUMERIK 840C Installation Instructions Manual page 45

2 General Reset and Standard Start-Up
2.9 General reset (up to SW 2)
"DELETE CYCLES-MD": The cycle setting data and MIB parameters are deleted
DELETE
and formatted.
CYCLES MD
The MIB parameters are the machine input buffers for the standard cycles during
program support.
Activating the RECALL key calls the general reset screenform.
"INITIALIZE MEMORY": The Initialize NC memory screenform is called.
INITIAL. ME-
MORY
"FORMAT USER DATA": Setting data, zero offsets, tool offsets, R parameters,
FORMAT
cycle setting data are deleted and formatted.
USER DATA
"FORMAT PART PROGRAM":
FORMAT
The dialog text DELETE DATA ? is displayed.
PART PROG.
If the Format part program softkey is pressed again, the part programs are dele-
ted and formatted.
Activating the PLC GENERAL RESET softkey calls the PLC functions screen-
PLC
form. The PLC general reset softkey is pressed again for starting PLC general
GEN. RESET
reset.
Activating the RECALL key calls the General reset screenform.
The "END START-UP" softkey is pressed to leave general reset mode. This re-
END
sults in the message "NCK RESET – please wait ..." and PLC restart, the pass-
START-UP
word is deleted and the JOG mode basic display is called.
2-14
Siemens AG 2001 All Rights Reserved 6FC5197–jAA50
09.95
SINUMERIK 840C (IA)