Drive Active Or Passive (As From Sw3) - Siemens SINUMERIK 840C Installation Instructions Manual

09.95
5.9.5

Drive active or passive (as from SW3)

Application For example, when using a 2-axis FDD module, one of the axes is disconnected
from the bus temporarily.
Procedure Switch the axis from the active to the passive state in the drive configuration
display. Confirm this setting with the Accept Conf + NCKP0 softkey.
You return to the previous state by switching the axis back to active and confir-
ming this setting with the Accept Conf + NCKP0 softkey.
Fig. 5.21
Siemens AG 2001 All Rights Reserved 6FC5197–jAA50
SINUMERIK 840C (IA)
5 Machine Data Dialog (MDD – as from SW 3)
5.9.5 Drive active or passive (as from SW3)
5–47