Siemens SINUMERIK 840C Installation Instructions Manual page 206

09.95
Absolute
D number
D1
D29
D30
D54
D55
D149
D150
D204
228
229
230
231
232
Default value
0
If a mode is selected and the standard system basic menu for this mode does not appear on
the screen, it is possible to define any user menu as the new basic menu for this mode by
entering the user menu number.
If value 0 is entered, the standard system basic menu when this mode is selected.
Note:
A change of NC MD 228 - 232 becomes valid the next time this mode is selected.
©
Siemens AG 1992 All Rights Reserved
SINUMERIK 840C (IA)
6 NC Machine Data (NC MD), NC Setting Data (NC SD)
TO
D no. to be programmed
memory
for each TO area (for
display also)
D1
D29
D1
D25
D1
D95
D1
D55
User menu for MDA
User menu for JOG
User menu for TEACH-IN
User menu for AUTOMATIC
User menu for JOG/REFPOINT
Lower input limit Upper input limit
0
6FC5197- AA50
6.2 General machine data (general data)
TO area 1
TO area 2
TO area 3
TO area 4
Units
1 000 –
Active
see below
Active
siee below
Active
see below
Active
see below
Active
see below
6–21