Siemens SINUMERIK 840C Installation Instructions Manual page 131

09.95
Axes
S
S
S
S
S
Siemens AG 2001 All Rights Reserved 6FC5197–jAA50
SINUMERIK 840C (IA)
Name:
The name of the axis appears in this window when NC MD 5680 ff (axis
name) is set. Possible input values are: X–X15, Y–Y15, Z–Z15, A–A15,
B–B15, C–C15, U–U15, V–V15, W–W15, Q–Q15, E–E15.
Function:
Possible display texts are (when NC MD 5640.7 ff – axis exists–input = yes)
– "Linear" : NC MD 5640.5 ff (rotary axis)
Input = No
– "Rotary" : NC MD 5640.5 ff (rotary axis)
Input = Yes
– "Following" : NC MD 18440.0 ff (axis can be following axis) Input = Yes
– "Facing": NC MD 5720.1 ff (facing axis) Input = Yes
Setpoint:
The connection value of the setpoint appears in this window when NC MD
3840.6–7 ff (drive/measuring circuit module number) has been set.
For analog drives:
and digital drives:
Actual value 1:
The connection value of actual value 1 appears in this window when NC MD
2000.6–7 ff (drive/
measuring circuit module number) has been set.
For analog drives:
and digital drives:
Actual value 2:
The connection value of actual value 2 appears in this window when NC MD
13880.6–7 ff (drive/
measuring circuit module number) has been set.
For analog drives:
and digital drives:
5 Machine Data Dialog (MDD – as from SW 3)
"MC x.x" (Measuring circuit in
measuring circuit modules)
"DIG x.x" or "FDD x."
"MC x.x" (Measuring circuit in
measuring circuit modules)
"DIG x.x" or "FDD x."
"MC x.x" (Measuring circuit in
measuring circuit modules)
"DIG x.x" or "FDD x."
5.1 General remarks
5–3