Siemens SINUMERIK 840C Installation Instructions Manual page 117

4 MMC Area Diagnosis
4.6 BACKUP with Valitek streamer/PC link
2 Setup / Configure options
1
Setup WOP options
See Configuring Guide Graphic Programming System
2
Create WOP working file
Service function for creating a new WOP working file
3
Set I/O device
1
2
3
4
4 Set disk check
Settings for checking the consistency of the file system on the hard disk (similar to the
DOS command CHKDSK).
1
2
3
5
Adjust display (as from SW 5.6, for service only)
6
Return to previous menu
3 DR DOS shell
For service task only (password protected)
4 MMC system check (SERVICE mode)
Check sum of all the system software installed on the hard disk
5
OEM
For more detailed information please refer to the OEM documentation.
6 End (load MMC)
Starts the MMC
4–54
Valitek PST–160
Valitek PST2 – M1200
Valitek PST2 – M1200 to read PST–160 tapes
PC link
Set new configuration
To set the intervals at which the check file system procedure is to be per-
formed when the control is booted.
Reset to default configuration
Restore default setting, i.e. file check every 24 hours.
Return to previous menu
Siemens AG 2001 All Rights Reserved 6FC5197–jAA50
01.99 09.95
SINUMERIK 840C (IA)