Description Of The Spindle Modes; Open-Loop Control Mode; Selecting The Open-Loop Control Mode - Siemens SINUMERIK 840C Installation Instructions Manual

Siemens computer drive installation instructions
Hide thumbs Also See for SINUMERIK 840C:
Table of Contents

Advertisement

12 Functional Descriptions

12.7.2 Description of the spindle modes

12.7.2
Description of the spindle modes
The following is a description of the various modes in which the spindle may be operated. The
individual modes can be programmed by NC (part program MDA, overstore), PLC or command
channel (CC). The functions that are then available are given in each case.
The various command sources (NC, PLC or CC) have different priorities, i.e. they can interrupt
or interlock each other.
The various switching conditions and interlocks are dealt with in the section headed "Switching
logic".

12.7.2.1 Open-loop control mode

General
In the open-loop control mode, the spindle is issued with a setpoint for speed (or cutting rate)
and direction of rotation. The setpoint that has been input can be altered by "Speed override"
when necessary.
Actual value acquisition
The open-loop control mode normally requires no encoder for actual value acquisition
except if the spindle is to be used for thread-cutting or the "Revolutional feedrate" function
in which case an encoder must be mounted on the spindle.
If an encoder is fitted, it is also used in the open-loop control mode for monitoring and
displaying the actual values (of speed and position). The encoder must be mounted
directly on the spindle so that the actual speed and position of the spindle can be
measured.

Selecting the open-loop control mode

Open-loop control mode is selected by NC, PLC or command channel. The following
functions are possible:
PLC:
Request for open-loop control mode
Constant speed and direction of rotation:
IS:INITIALIZE
set speed from MD 449*
set direction of rotation with IS:SET ROTATION CW
CC:
Request for control mode
Constant speed and direction of rotation:
"S external" function
set S value (speed) and M3, M4 (rotation) or M5 (spindle stop) in user data of
command channel
NC:
Request for open-loop control mode
Constant speed and direction of rotation
programming of S value, M3, M4, M5, G94, G95, G97
Constant cutting rate
programming of S value, M3, M4, M5 and G96
Thread-cutting
programming of S value, M3, M4, M5 and G33, G34, G35
12–36
© Siemens AG 1992 All Rights Reserved
11.92
6FC5197- AA50
SINUMERIK 840C (IA)

Hide quick links:

Advertisement

Table of Contents
loading

This manual is also suitable for:

Simodrive 611-d

Table of Contents