3Rd Level: Configuring Withing The Machine Data Areas Of Individual Machine Data Displays (As From Sw 3) - Siemens SINUMERIK 840C Installation Instructions Manual

09.95
5.8.3 3rd level: Configuring within the machine data areas of individual machine data displays (as from SW 3)
5.8.3 3rd level: Configuring within the machine data areas of individual
machine data displays (as from SW 3)
Motor/
PS data
Axis (TEA3)
Motor/
PS data
Spindle (TEA3)
Motor/
PS data
General NC MD (TEA1)
General ba-
sic MD
Geometry motion (TEA1)
Geometry
MD
Channel (TEA1)
Channel
basic MD
Axis (TEA1)
Basic MD
Spindle (TEA1)
Spindle
basic MD
Gearbox interpolation (TEA1)
Memory configuration (TEA1)
DRAM
data
I/O device setting (TEA2)
DMP
config.
Alarms messages (TEA2)
General
PLC basic data (TEA2)
Program
Siemens AG 2001 All Rights Reserved 6FC5197–jAA50
SINUMERIK 840C (IA)
Monitoring Message Meas. sys.
limitation data data
Monitoring Message Meas. sys.
limitation data data
Monitoring Message Meas. sys.
limitation data data
Face axis Modes Keyswitch
functions
Coupled Coordin. Override
axis comb. transform.
Auxiliary Multichan- Gen. reset
functions nel display G groups
Monitoring Velocities Meas. sys.
limitation data
Monitoring Speeds Meas. sys.
limitation data
GI
axis
SRAM
data
Interrupts Process
alarms
Channel Axis
Interface
5 Machine Data Dialog (MDD – as from SW 3)
Controller Status
data data
Controller Status
data data
Controller Status
data data
Technology Computer
MD link
Tool offset
Controller Leadscrew
data error comp.
Controller
data
GI
spindle
Reconfig.
memory
Spindle
File
functions
File
functions
File
functions
File
functions
File
functions
File
functions
File
functions
File
functions
File
functions
File
functions
File
functions
File
functions
File
functions
5–35