ABB ACH550-01 User Manual page 83

ACH550 User's Manual
The Start-up assistant guides you through the basic
programming of a new drive. (You should familiarize yourself
with basic control panel operation and follow the steps outlined
above.) At the first start, the drive automatically suggests
entering the first task, Language Select. The assistant also
checks the values entered to prevent entries that are out of
range.
The Start-up assistant is divided into tasks. You may activate the
tasks one after the other, as the Start-up assistant suggests, or
independently.
Note: If you want to set the parameters independently, use the
Parameters mode.
The order of tasks presented by the Start-up assistant depends
on your entries. The following task list is typical.
Task name
Spin the motor
Commission drive
Application
References 1 & 2
Start/Stop Control
Protections
Start-up and control panel
Description
• Prompts for the control panel display
language selection
• Prompts for motor data
• Guides user through the rotation check
• Prompts for motor data
• Prompts for the application macro selection
• Prompts for the source of speed references 1
and 2
• Prompts for reference limits
• Prompts for frequency (or speed) limits
• Prompts for the source of the start and stop
commands
• Prompts for the start and stop mode
definition
• Prompts for acceleration and deceleration
times
• Prompts for current and torque limits
• Prompts for the use of Run enable and Start
enable signals
• Prompts for the use of the emergency stop
• Prompts for the Fault function selection
• Prompts for the Auto reset functions
selection
71