ABB ACH550-01 User Manual page 256

Code Description
3105 AR OVERVOLTAGE
Sets the automatic reset for the overvoltage function on or off.
0 =
DISABLE
1 =
ENABLE
• Automatically resets the fault (
3103
DELAY TIME
3106 AR UNDERVOLTAGE
Sets the automatic reset for the undervoltage function on or off.
0 =
DISABLE
1 =
ENABLE
• Automatically resets the fault (
3103
DELAY TIME
3107 AR AI<MIN
Sets the automatic reset for the analog input less than the minimum
value function on or off.
0 =
DISABLE
1 =
ENABLE
• Automatically resets the fault (
DELAY TIME
WARNING! When the analog input signal is restored, the drive may
restart, even after a long stop. Make sure that automatic, long delayed
starts will not cause physical injury and/or damage equipment.
3108 AR EXTERNAL FAULT
Sets the automatic reset for external faults function on or off.
0 =
DISABLE
1 =
ENABLE
• Automatically resets the fault (
delay set by 3103
operation.
244
– Disables automatic reset.
– Enables automatic reset.
, and the drive resumes normal operation.
– Disables automatic reset.
– Enables automatic reset.
, and the drive resumes normal operation.
– Disables automatic reset.
– Enables automatic reset.
, and the drive resumes normal operation.
– Disables automatic reset.
– Enables automatic reset.
DELAY TIME
ACH550 User's Manual
Range
0=DISABLE, 1=ENABLE
) after the delay set by
DC OVERVOLT
0=DISABLE, 1=ENABLE
) after the delay set by
DC UNDERVOLT
0=DISABLE, 1=ENABLE
< ) after the delay set by 3103
AI MIN
0=DISABLE, 1=ENABLE
1 or
EXT FAULT EXT FAULT
, and the drive resumes normal
Parameter listing and descriptions
2) after the