ABB ACH550-01 User Manual page 59

ACH550 User's Manual
2. On the input power cable, strip the sheathing back far
enough to route individual wires. Also strip the individual
wires.
5
2
4
3. On the motor cable, strip the sheathing back far enough to
expose the copper wire screen so that the screen can be
twisted into a pigtail. Keep the pigtail short to minimize noise
radiation. Also strip the individual wires.
4. Route the input power and motor cables through the clamps
and tighten the clamps. On the motor cable, 360
under the clamp is recommended to minimize noise
radiation.
Installing the drive
3
4
grounding
º
47