ABB ACH550-01 User Manual page 162

Bit Name
2 OFF3 CONTROL
3 INHIBIT_
OPERATION
4 RAMP_OUT_ZERO
5 RAMP_HOLD
6 RAMP_IN_
ZERO
7 RESET
8...9 Unused
150
Control Word
Value Comments
1 Continue operation (
0 Emergency stop, stop within time
defined by parameter 2208. Enter
, proceed to s
ACTIVE
WARNING! Ensure that the motor and
driven machine can be stopped using
this stop mode.
1 Enter
OPERATION ENABLED
also the Run enable signal must be
active. See parameter 1601
If parameter 1601 is set to
also activates the Run enable signal.)
0 Inhibit operation. Enter
.
INHIBITED
1 Normal operation.
Enter
RAMP FUNCTION GENERATOR
OUTPUT ENABLED
0 Force Ramp Function Generator output
to zero.
Drive ramps to stop (current and DC
voltage limits in force).
1 Normal operation.
Enter
RAMP FUNCTION GENERATOR
OUTPUT ENABLED
0 Halt ramping (Ramp Function Generator
output held).
1 Normal operation. Enter
0 Force Ramp Function Generator input to
zero.
0=>1 Fault reset if an active fault exists. Enter
-
SWITCH ON INHIBITED
parameter 1604 is set to
0 Continue normal operation.
ACH550 User's Manual
3 inactive).
OFF
-
WITCH ON INHIBITED
(Note that
RUN ENABLE
, this bit
COMM
OPERATION
:
.
:
.
OPERATING
. Effective if
.
COMM
Serial communications
3
OFF
.
.
.