ABB ACH550-01 User Manual page 67

ACH550 User's Manual
Check installation
The installation preparations have been com-
pleted according to the installation checklist.
The drive is mounted securely.
The space around the drive meets the drive's
specifications for cooling
location
The motor and driven equipment are ready for
start.
For IT systems, corner grounded TN systems
and residual current circuit breakers: the inter-
nal EMC filter is disconnected
ing installation (R1...R4)
of wiring installation (R5...R6)
The drive is properly grounded.
The input power (mains) voltage matches the
drive's nominal input voltage.
The input power (mains) connections at U1, V1
and W1 are connected and tightened as speci-
fied.
The input power (mains) fuses and mains
switch are installed.
and fuses
The motor connections at U2, V2 and W2 are
connected and tightened as specified.
The motor cable is routed away from other
cables.
NO power factor compensation capacitors are
in the motor cable.
The control connections are connected and
tightened as specified.
Installing the drive
Check
on page 23).
(Input power (mains) cable
on page 378).
(Suitable mounting
(Overview of wir-
on page 44, Overview
on page 45).
55