ABB ACH550-01 User Manual page 78

Standard display mode
Use the standard display mode to read information on the drive's
status and to operate the drive. To go to the standard display
mode, press EXIT until the LCD display shows status
information as described below.
Status information
Top. The top line of the LCD display shows the basic status
information of the drive.
• HAND – Indicates that the drive control is local, i.e., from the
control panel (operator keypad).
• AUTO – Indicates that the drive control is remote, such as
the basic I/O (X1) or fieldbus.
• – Indicates the drive and motor rotation status as follows:
Control panel display
Rotating arrow (clockwise or
counterclockwise)
Dotted rotating arrow
Stationary arrow
Dotted stationary arrow
• Upper right – shows the active reference.
Center. Using parameter
PANEL DISPLAY, the center of the LCD
display can be configured to display:
• Three signals from
OPERATING DATA
display shows parameters 0103 (
(
CURRENT
• A bar meter instead of each signal
value.
66
Group 34:
Group 01:
– The default
) in amperes and 0120 (
ACH550 User's Manual
Significance
• Drive is running and at
setpoint.
• Shaft direction is forward
or reverse.
Drive is running but not at
setpoint.
Drive is stopped.
Start command is present, but
the motor is not running, e.g.
because start enable is
missing.
) in hertz, 0104
OUTPUT FREQ
1) as a percentage.
AI
Start-up and control panel