ABB ACH550-01 User Manual page 220

Code Description
1606 LOCAL LOCK
Defines control for the use of the HAND mode. The HAND mode allows
drive control from the control panel (operator keypad).
• When
LOCAL LOCK
HAND mode.
0 =
NOT SEL
control the drive.
1 = 1 – Defines digital input
DI
• Activating the digital input locks out local control.
• De-activating the digital input enables the HAND selection.
2...6 = 2...
DI
the local lock.
• See 1 above.
DI
7 = – Sets the lock. The control panel cannot select HAND, and
ON
cannot control the drive.
8 = – Defines bit 14 of Command Word 1 (parameter 0301) as the
COMM
control for setting the local lock.
• The Command Word is supplied through fieldbus communication.
-1 = 1(
DI INV
setting the local lock.
• De-activating the digital input locks out local control.
• Activating the digital input enables the HAND selection.
-2...-6 =
DI
as the control for setting the local lock.
• See 1(
DI
1607 PARAM. SAVE
Saves all altered parameters to permanent memory.
• Parameters altered through a fieldbus are not automatically saved to
permanent memory. To save, you must use this parameter.
• If 1602
PARAMETER LOCK
the control panel (operator keypad) are not saved. To save, you must
use this parameter.
• If 1602
PARAMETER LOCK
control panel are stored immediately to permanent memory.
0 = – Value changes automatically when all parameters are
DONE
saved.
1 = – Saves altered parameters to permanent memory.
SAVE
208
is active, the control panel cannot change to
– Disables the lock. The control panel can select HAND and
6 – Defines digital input
DI
) – Defines an inverted digital input
2( )... 6( ) – Defines an inverted digital input
INV DI INV
) above.
INV
= 2 (
= 1 (
ACH550 User's Manual
Range
-6...8
1 as the control for setting the local lock.
DI
2... 6 as the control for setting
DI DI
DI
0=DONE, 1=SAVE
), parameters altered from
NOT SAVED
), parameters altered from the
OPEN
Parameter listing and descriptions
1 as the control for
2...
DI
6
DI