ABB ACH550-01 User Manual page 178

• Group 21: START/STOP
stops.
• Group 22: ACCEL/DECEL
rate of acceleration and deceleration.
• Group 23: SPEED CONTROL
control.
• Group 25: CRITICAL SPEEDS
speed ranges.
• Group 26: MOTOR CONTROL
variables.
• Group 29: MAINTENANCE TRIG
trigger points.
• Group 30: FAULT FUNCTIONS
responses.
• Group 31: AUTOMATIC RESET
automatic resets.
• Group 32: SUPERVISION
• Group 33: INFORMATION
• Group 34: PANEL DISPLAY
panel display.
• Group 35: MOTOR TEMP MEAS
overheating detection and reporting.
• Group 36: TIMED FUNCTIONS
• Group 40: PROCESS PID SET 1
control operation mode for the drive.
• Group 41: PROCESS PID SET 2
control operation mode for the drive.
• Group 42: EXT/TRIM PID
PID.
• Group 51: EXT COMM MODULE
for fieldbus communication module.
• Group 52: PANEL COMM
fieldbus system.
• Group 53: EFB PROTOCOL
EFB communication.
• Group 81: PFA CONTROL
alternation mode of operation.
• Group 98: OPTIONS
166
– Defines how the motor starts and
– Defines ramps which control the
– Defines variables for speed
– Defines critical speeds or
– Defines motor control
– Defines usage levels and
– Defines faults and
– Defines conditions for
– Defines supervision for signals.
– Contains software information.
– Defines the content for control
– Defines motor
– Defines timed functions.
– Defines a process PID
– Defines a process PID
– Defines parameters for External
– Defines set-up variables
– Defines settings for Modbus
– Defines set-up variables for
– Defines pump and fan
– Configures options for drive.
Parameter listing and descriptions
ACH550 User's Manual