ABB ACH550-01 User Manual page 218

Code Description
1603 PASS CODE
Entering the correct pass code unlocks the parameter lock.
• See parameter 1602 above.
• Code 358 opens the lock.
• This entry reverts back to 0 automatically.
1604 FAULT RESET SEL
Selects the source for the fault reset signal. The signal resets the drive
after a fault trip if the cause of the fault no longer exists.
0 =
KEYPAD
• Fault reset is always possible with control panel.
1 = 1 – Defines digital input
DI
• Activating the digital input resets the drive.
2...6 = 2...
DI
• See 1 above.
DI
7 = /
START
• Do not use this option when fielbus communication provides the
start, stop and direction commands.
8 = – Defines the fieldbus as a fault reset source.
COMM
• The Command Word is supplied through fieldbus communication.
• The bit 4 of Command Word 1 (parameter 0301) resets the drive.
-1 = 1(
DI INV
source.
• De-activating the digital input resets the drive.
-2...-6 =
DI
as a fault reset source.
• See 1(
DI
206
– Defines the control panel as the only fault reset source.
6 – Defines digital input
DI
– Defines the Stop command as a fault reset source.
STOP
) – Defines an inverted digital input
2( )... 6( ) – Defines an inverted digital input
INV DI INV
) above.
INV
ACH550 User's Manual
Range
0...65535
-6...8
1 as a fault reset source.
DI
2... 6 as a fault reset source.
DI DI
DI
Parameter listing and descriptions
1 as a fault reset
2...
DI
6
DI