Profile Management-File Menu; Other Menu; Load Tape - Honeywell Vertex M Technical Handbook

Vertex M 24-Point Continuous Monitor
TM

3.6.9 Profile Management-File Menu

Use the file menu to open, create, save or close a
configuration file. Configuration files may be stored in
any directory on the Vertex M System hard disk.
When you make any changes to the configuration
profile, Vertex M will always prompt you to save the
change before closing the Configuration window.
Section 3 - Startup

3.6.10 Other Menu

The Other Menu offers several shortcuts to speed
configuring the Vertex M System.

3.7 Load Tape

After configuring the analyzers, load each analyzer with
the proper Chemcassette
gas. See Section 5.3.4 Change Chemcassette® Tape
for loading procedure. See Detectable Gases, for a list
of target gases and Chemcassette
After installing Chemcassettes
keep the analyzer in IDLE mode. Do not move to
monitor mode until you have:
Performed a leak check on sample lines. See
3.8 Leak Checking Sample
Verified flow rates See
3-34
Copy Az definition
Copies the configuration
of one analyzer to any
other analyzer in the
system. There are two
options when copying an
analyzer configuration:
Copy Gas Location Name
Copies the location from the
first analyzer to the second
analyzer.
Copy *.htm File Name
Assigns the instruction file for
the first analyzer to the second
analyzer.
Alarm Defaults
Sets the level 1 and level 2
alarms of all analyzers not
yet configured to the following
values:
* One-half TLV and TLV
* TLV and two times TLV
* One-half TLV and two times TLV
tape required for the target
®
tape part numbers.
®
for initial configuration,
®
Lines.
Section 3.9.1 Verify Flow
Section
Rates.