Introduction; Monitoring Mode Overview - Honeywell Vertex M Technical Handbook

Vertex M 24-Point Continuous Monitor
TM

4.1 Introduction

This chapter describes Vertex M operation including
monitoring, system control and data viewing.
This chapter includes the following sections:
•

4.2 Monitoring Mode Overview

• 4.3 Main Screen
• 4.4 Project Functions
• 4.5 Review Functions
• 4.6 Menu Buttons
• 4.7 OnScreen Keyboard
See Section 3 Startup
System have not yet been configured.
Section 4 - Operation
if the analyzers in the Vertex M
4.2 Monitoring Mode Overview
Monitor mode is the Vertex M System's standard
operating state. Upon power up, the monitor performs
initialization routines and returns to the same state as
when powered down. During monitoring, the Vertex M
System will calculate concentrations every second for
each of the enabled points. Concentrations are used for:
• Triggering alarm relays
• Viewing in the main screen
• Entries in the event list
• Viewing in point detail screen
Concentration information is available through the:
• Point detail screen
• OPC
• Optional fieldbuses
• Optional 4-20 mA output
• Data logger
4-2