Honeywell Vertex M Technical Handbook page 156

Event Event List
Number Desc. (Short)
241 OPT REF ADJ
TIMEOUT
270 COM AZ # #
BROKEN
301 PLC-COM
BROKEN
302 AZ-BAD PROF
ID
303 PLC-BAD
PROF ID
304 PLC SYSTEM
FAULT
305 DATA LOG
FAILED
413 CMD ERR AZ
#-#
Section 6 - Troubleshooting
Event History
Data Field
Description
Optics reference Error code
adjustment
timeout
OPC To Az ##
Communica-tions
Broken
PLC-Com
Broken
AZ has wrong
profile loaded
PLC Has Wrong
Profile loaded
PLC System PLC Error
Fault Code
Unable To Log
Conc Data
Cmd Error Az #-#
Problem
Optics block self-
adjustment timeout.
Analyzer not Analyzer powered down
responding to OPC
driver polling request
Ethernet cable not
connected
PLC fails to respond to Cable connection
DAq communication problem
Loss of PLC power
Profile ID in analyzer Configuration not properly
does not match current loaded
configuration in use
Profile ID in PLC does Configuration not properly
not match current loaded
configuration in use
A fault has occurred on Faulty or missing PLC
the PLC that prevents module
the PLC program from
PLC is not properly
running
configured
Failure to store Local database file has
concentration data in reached size limit (1GB
the database maximum size for Access
database).
Analyzer not Cable connections
responding DAq
Communica-tions
Analyzer missing or
powered down
6-16
Possible Cause
Cycle power to analyzer.
Contact Honeywell service.
Check switch on power
module
Check Ethernet
connection at the back of
the analyzer
Move cable to different
port on Ethernet hub
Check serial
communications on DAq
COM2
Check serial cable on
PLC 1747-KE
See Section 1.2.7 Data
Acquisition Computer
(rear)
See Section 1.2.9 Main
PLC
Check power connections
for PLC
Reinstall current
Configuration Profile
Reinstall current
Configuration Profile
Contact Honeywell
Analytics Service
Enable automatic
database purge or adjust
database purge settings
to purge old data
Check Ethernet
connections
Remove analyzer from
Configuration Profile
Recovery