Honeywell Vertex M Technical Handbook page 155

Event Event List
Number Desc. (Short)
233 FAIL OPT
VERIFY
234 GRAY FAILED
235 AZ SW VER
WRONG
237 AZ VACUUM
LOW
238 OP SW
MISMATCH
239 OPTICS COMM
FAIL
240 OPTICS REF
FAIL
Section 6 - Troubleshooting
Event History
Data Field
Description
Optics Adj Cnts
Verification
Failed
Light Gray Read Optics Cnts
Failed
Analyzer 0
software version
mismatch
Inadequate Observed
Analyzer Vacuum vacuum in in
Hg
Optics block 0
software
mismatch.
Optics block Error code
communication
failure
Optics reference Reference
limit exceeded value signal
Problem
Optics Verification Chemcassette leader
Failed not tight or improperly
positioned during
light gray to dark gray
calibration
Bad RFID tag
Dirty optics block
Bad optics PCB set
Optics values of this Chemcassette leader
field were outside limits not tight or improperly
positioned during
light gray to dark gray
calibration
Bad RFID tag
Dirty optics block
Bad optics PCB set
Software mismatch
Individual analyzer Fault 219 has triggered.
observes inadequate
vacuum, stops
Circular tubing harness
monitoring
disconnected
Tubing pinched
The two optics blocks Program update done
are not running the same incorrectly.
software version.
Analyzer is not able to Cable disconnected.
communicate with the Software anomaly.
optics block. Defective optics block.
The signal detected at Degraded optics block.
the reference photodiode
is out of range.
6-15
Possible Cause
Reload Chemcassette
Load new Chemcassette
Clean and recalibrate
Service or replace
analyzer
Reload Chemcassette
Load new Chemcassette
Clean and recalibrate
Service or replace
analyzer
Reload program to all
analyzers
Contact Honeywell
service
Recover from Fault 219,
then reset Fault 237
Connect circular tubing
harness
Correct tubing dress in
cable carrier
Contact Honeywell
Service
Reload program to both
optics blocks.
Check the 14 pin
cable connection on
the sensor board.
Cycle power to analyzer.
Contact Honeywell service.
Contact Honeywell service.
Recovery