Configure Point - Honeywell Vertex M Technical Handbook

Vertex M 24-Point Continuous Monitor
TM

3.6.4 Configure Point

The Configure Point window provides the following options for each point:
When all of the entries are correct for the point, use either the point selection buttons or choose Next Point/
Last Point to scroll to the next point in the analyzer. Press Done when all settings are entered.
Section 3 - Startup
Select the specific target gas
Designate the location of the target gas
Set alarm levels
Enable/disable point
Gas Calibration
Select the target gas from the dropdown list.
Only the gases valid for the family of gases
chosen for the designated tape will appear.
Last Point / Done / Next Point Buttons
Configure concentration logging
Configure point-specific event help
Set PLC full-scale concentration
Warning
Select Warning to create an alarm when a gas
concentration exceeds the Lower Detection Limit (LDL).
See Appendix A Detectable Gases
of LDLs. Warnings appear as a "W" on the main screen
with no relay actions.
3-21
for a complete list