Honeywell Vertex M Technical Handbook page 81

Vertex M 24-Point Continuous Monitor
TM
Status Indicators
The indicator displays brief information about analyzer
status such as faults, warnings or maintenance
functions in process.
Point 1
Point 2
Point 3
Point 4
Status indicators include:
• IDLE - the analyzer is not monitoring or
performing maintenance
• MONT - the analyzer is monitoring
• LD CC - Load Chemcassette
progress
• PROG - a new application program is being
loaded into the analyzer
• CONF - a new configuration is being loaded
into the analyzer
• COMF - a communications failure between the
DAq and the analyzer
• PYRO-W - a pyrolyzer analyzer is warming
up. When pyrolyzer has reached stable
temperature, it will automatically go into
monitor
• FLOW - a flow Auto Balance procedure is in
process on the analyzer
Section 4 - Operation
The Vertex System displays only the short names of
the location and target gases within each point block.
During normal monitoring, the background color of each
block is white. Vertex will change the background color
of a point as conditions change.
Point 5
Point 6
Point 7
Point 8
Alarm Indicators
When the target gas concentration for a point reaches
a preset alarm level, Vertex will display a W, 1 or 2 in
the point block to indicate the severity of the alarm.
routine is in
®
See
setting Alarm Level 1 and Alarm Level 2.
See
alarm default values.
4-5
White Normal operation.
Alarms for the point are disabled in
Blue
the runtime options menu.
Point is disabled in the runtime menu
Grey
or is disabled due to a fault.
Gas concentration exceeded an
Red
Purple Disable configuration alarm
Point is not configured for
Black
Table 4-1.
Alarm
Concentration Threshold
Indicator
W (if enabled) Lower Detectable Limit (LDL)
1
2
Section 3.6.4 Configure Point
Section 3.6.10 Other Menu
alarm level.
monitoring.
Alarm Level 1
Alarm Level 2
for information on
for information on