Xerox Phaser 3635MFP Service Manual page 32

05-920 DADF Door Open RAP
05-920 The machine has detected that the DADF door is open.
Procedure
WARNING
Switch off the electricity to the machine. Disconnect the power cord from the customer
supply while performing tasks that do not need electricity. Electricity can cause death or
injury. Moving parts can cause injury.
Refer to Wiring Diagram 10. Perform the following:
1. Open the DADF door assembly, PL 5.10 Item
actuator is not missing or damaged. If necessary, install a new DADF door assembly,
5.10 Item 3.
2. Enter dC330 Component Control code 05-160. Check the DADF door open sensor (Q05-
160), PL 5.40 Item 13.
3. Check the wiring between the DADF door open sensor and CN5 on the
necessary, install a new DADF door open sensor,
4. If necessary, install a new DADF PWB,
Status Indicator RAPs
05-920
3. Check that the DADF door open sensor
DADF
PL 5.40 Item 13.
PL 5.15 Item 16.
PL
PWB. If
April 2010
2-18 Phaser 3635MFP/WorkCentre 3550