Gp 12 User Interface Tests Description - Xerox Phaser 3635MFP Service Manual

GP 12 User Interface Tests Description

Purpose
To describe the user interface tests that are available in
dC305 UI Test.
Procedure
Refer to the relevant procedure:
• User Interface Button Test (3635)
• Audio Tone Test (3635)
• LED Indicator Test (3635)
• Touch Area Test (3635)
• Display Pixel Test (3635)
• Video Memory Test (3635)
• Reset User Interface (3635)
• Application Checksum Verification (3635)
• Touch Screen Calibration (3635)
• Reduced Panel UI Test (3550)
• Complete Panel UI Test (3550)
User Interface Button Test (3635)
Use this test to verify that the buttons on the user interface are working correctly. After entering
this test, follow the instructions displayed on the user interface to perform, then exit the test.
Audio Tone Test (3635)
Use this test to verify that the audio tone on the user interface is working correctly. After enter-
ing this test, follow the instructions displayed on the user interface to perform, then exit the test.
LED Indicator Test (3635)
Use this test to verify that the LEDs on the user interface is working correctly. After entering this
test, follow the instructions displayed on the user interface to perform, then exit the test. Each
LED will flash on for approximately 1 second, then off sequentially in a clockwise direction.
Touch Area Test (3635)
Use this test to verify that the touch screen on the user interface is working correctly. After
entering this test, follow the instructions displayed on the user interface to perform, then exit
the test.
Display Pixel Test (3635)
Use this test to verify that the liquid crystal display module (LCDM) is working correctly. After
entering this test, follow the instructions displayed on the user interface to perform, then exit
the test.
Video Memory Test (3635)
Use this test to verify that the SRAM used by the video controller on the user interface is work-
ing correctly. After starting this test, each video SRAM location will be validated.
General Procedures/Information
GP 12
GP 4 System Administration Tools and
April 2010
6-20
Reset User Interface (3635)
This procedure will reset the user interface.
Application Checksum Verification (3635)
This procedure will check the user interface application software checksum and any software
in the extended memory.
Touch Screen Calibration (3635)
Use this test to re-calibrate the touch screen. After entering this test, follow the instructions dis-
played on the user interface to perform, then exit the test.
Reduced Panel UI Test (3550)
Use this test to verify that the buttons on the user interface are working correctly. After entering
this test, follow the instructions displayed on the user interface to perform, then exit the test.
Complete Panel UI Test (3550)
Use this test to verify that the liquid crystal display module (LCDM) and the buttons on the user
interface are working correctly. After entering this test, follow the instructions displayed on the
user interface to perform, then exit the test.
Phaser 3635MFP/WorkCentre 3550