Example 1: Creating A Set Of Ties - Extron electronics DXP DVI Pro User Manual

4. Press and release the Enter button to accept the tie or to break an existing tie.
5. Repeat steps 1 through 4 to create or clear additional ties until the desired configuration
is complete.
NOTES:
•
•
•
•
•

Example 1: Creating a Set of Ties

In the following example, input 5 is tied to outputs 3, 4, and 8. The steps show the front
panel indications that result from your actions.
NOTE: This example assumes that there are no ties in the current configuration.
1. Press and release the Esc
Press the Esc button to clear all
ENTER
Figure 12.
2. To select video and audio for the tie, press and release the Video and Audio buttons
as necessary until both the buttons light.
NOTE: Because the DXP DVI series switchers do not support audio, you cannot
create audio ties. Pressing the Audio button has no effect.
Press the Video button to toggle on and off.
The button lights green when selected.
Figure 13.
Only one input can be tied to an output. If you tie an input to an output that is
already tied to another input, the older tie is broken in favor of the newer tie.
If an input with no tie is selected, only the button for the selected input lights (no
output buttons light).
If you press the input button for an I/O grouped input and then try to select an
output in a different group, the associated output button cannot be selected,
and the selected input button remains lit (see
more information).
As each input and output is selected, the associated output button blinks
the appropriate color to indicate a tentative tie. Buttons for outputs that were
already tied to the input light the appropriate color steadily. Outputs that are
already tied can be left on, along with new blinking selections, or toggled off by
pressing the associated output button.
When the Video and Audio buttons are lit, if an input with an audio tie but no
video tie is selected, the selected input button lights amber and the output
button lights the appropriate color (red, green, or amber).
>
button.
selections.
C O N T R O L
VIEW ESC
PRESET
The button blinks once.
Clear all Selections
I / O
VIDEO
Select Video and Audio
I/O Grouping
AUDIO
Press the Audio button to toggle on and off.
The button lights red when selected.
DXP DVI Pro and DXP HDMI Series • Operation
on page 32 for
20