Using Emulation Mode - Extron electronics DXP DVI Pro User Manual

Help menu
From this menu you can open the Matrix Switcher Control Program help file.
Figure 100.
• Contents — Displays the Matrix Switcher + Help program, in which you can find
procedures for using the software to control and configure the DXP.
Switcher information — The two sections below the Contents option are not
•
menu options; they display information about your switcher:
Model — DXP model name
•
Config — Video and audio matrix size: V(
•
Firmware Ver. — Firmware version to second decimal place
•
LoggedOn as: — Administrator or User
•
Connection – (For RS-232 or RS-422) "Com n" –
•
"IP – [IP address]"
About this Program — Opens a window that displays information about the current
•
version of the Matrix Switcher Control Program.

Using Emulation Mode

Emulation mode lets you set up the software without connecting the DXP to the computer.
NOTE: In emulation mode, you can emulate any matrix switcher that is supported by the
Matrix Switcher Control Program; you are not limited to the DXP.
1. Double-click the MATRIX Switchers + Control Program icon in the Extron
Electronics group or folder.
2.
On the Comm Port Selection window, select Emulate, then click OK.
3. On the Initialize Emulated Matrix settings from... window, select an
emulation file (.mtx extension), then click Open.
IP Connection
DXP DVI Pro and DXP HDMI Series • Matrix Software
Serial Connection
x ) A( x )
n n n n
," or (for IP)
baud rate
101