Resetting; Resetting The System From The Front Panel - Extron electronics DXP DVI Pro User Manual

Resetting

There are several methods by which you can reset the DXP, and some of these methods
allow for four levels of resetting. The following reset methods are available on the DXP:
•
•
•
•

Resetting the System from the Front Panel

The front panel reset is identical to the
switcher
•
•
•
NOTE: The system reset clears most image and audio adjustments. If you want to save
To reset the switcher to the factory default settings, press and hold the Video and Audio
buttons while you apply AC power to the switcher.
NOTE: System reset does not reset the Internet protocol (IP) settings or replace
The buttons blink, then
become unlit.
Figure 60.
Front panel buttons (see "Resetting the System from the Front Panel")
Rear panel Reset button (see
the next page.)
SIS commands (see the Resets
SIS Commands, page 64.)
Matrix Switchers Control Software (see
page 68).
on page 64). A system reset does the following:
Clears all ties and presets
Clears all video and audio mutes
Resets all I/O grouping
these settings, use the Matrix Switchers Control Program and select Save MATRIX
settings as... from the File menu before you perform this reset (see
starting on page 64).
user-installed firmware.
Press and hold the Video and Audio
buttons while you apply power to the
switcher.
I / O
VIDEO AUDIO
Continue to hold the Video and Audio
buttons until all input and output buttons
return to either unlit or to background
illumination and the Video and Audio
buttons light.
Release the Video and Audio buttons.
System Reset
Resetting Using the Rear Panel Reset Button
commands in the Command and Response Table for
IP-specific SIS Commands
E
}
ZXXX SIS command (see
Power
DXP DVI Pro and DXP HDMI Series • Operation
on
on
Reset whole
Resets
40