Using The Command And Response Tables For Sis Commands; Special Characters - Extron electronics DXP DVI Pro User Manual

E25 — Device not present
E26 — Maximum number of connections exceeded
E27 — Invalid event number
E28 — Bad filename or file not found
E30 — Hardware failure (followed by a colon [:] and a descriptor number)
E31 — Attempt to break port pass-through when it has not been set
NOTE: User privileges extend to all view and read commands except reading the

Using the Command and Response Tables for SIS Commands

The
Upper- and lowercase letters are acceptable in the command field except where indicated.
The table below shows the hexadecimal equivalent of each ASCII character used in the
command/response table.
Space
Figure 69.

Special Characters

Use of the following characters is not recommended as part of preset names, the switcher
name, passwords, or locally created file names:
+ ~ , @ = ` [] {} < > '' "" ; (semicolon) : (colon) | \ ? and {space}.
administrator password. Users can also perform the following functions:
• Creating ties
• Recalling presets
• Muting outputs
Command and Response Table for DXP SIS Commands
ASCII to Hex Conversion Table
ASCII to Hexadecimal Conversion
DXP DVI Pro and DXP HDMI Series • SIS Configuration and Control
starts on page 57.
•
53