Extron electronics DXP DVI Pro User Manual page 80

Command
IP Setup Commands (continued)
Set serial port parameters
Read serial port parameters
Configure receive timeout
The Configure command is sufficient as shown for most users, with the priority (
NOTE:
omitted. The response in this case is
returned.
Read receive timeout
Set mode
Read mode
Set verbose mode
Read verbose mode
Configure current port timeout
Read current port timeout
Configure global IP port timeout
Read global IP port timeout
ASCII Command
(Host to Switcher)
EX4& X4* X4( X5) X5!
* , , ,
EX4& }
CP
EX4& X5% X5^ }
* , CE
X4& X5%
Cpn
•Cce
EX4& }
CE
EX4& X5@ }
* CY
EX4& }
CY
EX5# }
CV
E }
CV
E X5$ }
0* TC
E }
0TC
E X5$ }
1* TC
E }
1TC
DXP DVI Pro and DXP HDMI Series • SIS Configuration and Control
Response
Additional Description
(Switcher to Host)
}
CP
X4& X4* X4( X5)
•Ccp
Cpn , ,
X4&
= Port number 01 – 99
X4*
= Baud rate: 9600 (default), 19200, 38400, 115200
X4(
= Parity: Odd, Even, None (default), Mark, Space
Enter only the first letter.
X5)
= Data bits: 7 or 8 (default)
X5!
= Stop bits: 1 (default) or 2
X4* X4( X5) X5!]
, , ,
X4& X5% X5^ X5*
Cpn •Cce , ,
X4&
= Port number 01 – 99
X5%
= Time (in 10 ms increments) to wait for characters.
10 = 100 ms (default) through 32767
X5^
= Time (in 10 ms increments) to wait between
characters. 2 = 20 ms (default) through 32767
X5&
= Message length, delimiter value, or byte count (via the
serial port)
#L = Length of message to be received
#D = Delimiter value
# = byte count (1 through 32767)
X5*
= Priority status for receiving timeouts
0 = Use Send data string command parameters
1 = Use Configure receive timeout parameters
X5*
) and length or delimiter (
X5^
, ,0,00000L
], with the default
X5$ X5%]
,
X4& X5@] X5@
Cpn •Cty
X5@]
X5#]
Vrb
Enable or disable verbose mode and tagged responses
X5#
,
where additional information is provided in response to
a query.
0 = Clear or none (default for Telnet connections)
1 = Verbose mode (default for RS-232 and USB)
2 = Tagged responses for queries
3 = Verbose mode and tagged queries
X5#]
X5$] X5$
Pti0*
in 10-second increments)
1 = 10 seconds through 65000
10 = 100 ms (default) through
X5$]
X5$]
Pti1*
X5$]
X5!]
,
X5&]
,
X5&
)
X5& X5*
and values
= Port type
0 = RS-232 (default)
1 = RS-422
= Port interval timeout
(Default is 30 = 300 seconds
= 5 minutes.)
32767
72