Configuration Port - Extron electronics DXP DVI Pro User Manual

Digital matrix switchers
Hide thumbs Also See for DXP DVI Pro:
Table of Contents

Advertisement

Configuration Port

C
Control Buttons
Primary Functions
Action:
Indication:
Secondary Functions
Action/
I/O Grouping
indication:
Action 1:
Port
Action 2/
configuration
indication:
Front panel
Action:
locks
D
Config port — (See
figure 10
Remote RS232/RS422 connector on the DXP rear panel (see
Remote Connections
on page 10). The Config port (RS-232 only) can be used for
system configuration and control via SIS commands or the control software. To connect
to this port, see
RS-232 Config port (front panel)
The following table summarizes the primary and secondary functions of the four control
buttons.
ENTER
Save changes.
Blink: Save
needed
Select group 1.
Select Configuration Mode
Select 9600 baud.
Blink: Selected
With Video and
Audio, select lock
mode 2 or toggle
between modes 0
and 2.
Enter button — (see figure 10) The Enter button does the following:
Primary functions ():
 Saves changes that you make on the front panel.
 Indicates that a potential tie has been created but not saved.
 Indicates that a global preset has been selected to be saved or recalled but that
the preset action has not been accomplished.
Secondary functions (
):
In I/O grouping mode, selects group 1 (see
In I/O grouping mode, indicates that group 1 is selected.
With the Preset, View
configuration mode (see
Rate (Rear Panel)
on page 44).
Selects 9600 baud for the Remote RS232/RS422 and the RS-232 Config ports in
serial port configuration mode.
Indicates that the Remote RS232/RS422 and the RS-232 Config ports are set to
9600 baud in serial port configuration mode.
on page 13) This RS-232 port is an alternative to the
on page 11.
PRESET
Select preset
Select view
mode.
mode.
Blink: Save preset.
View the selected
Lit: Recall preset.
mode.
Select group 2.
Select group 3.
Select 38400
Select 19200 baud.
baud.
Blink: Selected
Blink: Selected
I/O Grouping
<
>
, and Esc
buttons, places the switcher in serial port
Selecting the RS-232/RS-422 Port Protocol and Baud
DXP DVI Pro and DXP HDMI Series • Operation
RS-232 and RS-422
ESC
VIEW
Cancel or
escape.
Blinks once.
Select group 4.
Select 115200
baud.
Blink: Selected
on page 32).
15

Advertisement

Table of Contents
loading

This manual is also suitable for:

Dxp hdmi

Table of Contents