Extron electronics DXP DVI Pro User Manual page 45

3. To select both video and audio for viewing and muting, if necessary, press and release
the Video and Audio buttons.
NOTE: This example shows the front panel indications if examples 1, 2, and 3 have
been completed.
Press the Video button to
toggle video on and off.
The button lights green
when selected.
Until you select an input, the buttons for all untied
outputs light amber if no inputs are tied, green if
no video inputs are tied (only audio is tied), or
red if no audio inputs are tied (only video is tied).
1 2 3 4
Figure 54. Select Video and Audio
NOTE: Output mutes are protected when front panel lock mode 2 is selected. You
can view the mutes in lock mode 2 but you cannot change them from the front
panel (see Locking and Unlocking the Front Panel (Executive Modes)
page 38).
If front panel lock mode 2 is selected and you try to perform steps 4 and 5, the
actions are ignored. Set the lock mode to 0 to enable changes.
4. One at a time, press and hold the Output 3 button and then the Output 4 button
until each button begins to blink (approximately 2 seconds). The output 3 and output 4
video and audio signals are muted.
Mute outputs one at a time.
Press and hold the Output 3 button.
3
2 seconds
NOTE: Video and audio are muted in
this example.
Press and hold the Output 4 button.
4
2 seconds
NOTE: Video is muted in this example.
Figure 55. Mute the Outputs
NOTES:
•
If both video and audio are selected, the mute action toggles both the video
and audio outputs. If either the video output or the audio output is already
muted, the unmuted output is muted and the muted output is unmuted.
• If both video and audio are selected and only video is muted, the output button
blinks between green and amber. If only audio is selected, the output button
blinks between red and amber.
Press the Audio
I / O
button to toggle audio
on and off.
VIDEO AUDIO
The button lights red
when selected.
INPUTS
5 6 7 8
The button blinks to indicate
3
that the output is muted.
Green = Video is muted.
Red = Audio is muted.
Amber = Video and audio are muted. (Amber is visible only after
you have selected the Video and Audio buttons).
4 The button blinks to indicate
that the output is muted.
DXP DVI Pro and DXP HDMI Series • Operation
on
37