Extron electronics DXP DVI Pro User Manual page 77

X4$
= Notification selections, part 2
X4%
= Notify when?
X4^
= DHCP
X4&
= Port number
X4*
= Baud rate
X4(
= Parity
X5)
= Data bits
X5!
= Stop bits
X5@
= Port type
X5#
= Verbose mode
If tagged responses is enabled (modes 2 and 3), all read commands return the constant
NOTE:
string and the value as the set command does (for example, the read matrix name command
E } X3)]
CN , returns Ipn•
X5$
= Port timeout interval
(in 10 second increments)
X5%
= Time (in 10 ms increments) to
wait for characters
X5^
= Time (in 10 ms increments) to wait
between characters
X5&
= Message length, delimiter value,
or byte count (via the serial port)
X5*
= Priority status for receiving
timeouts
X5(
= Subnet mask
X6)
= Gateway address
DXP DVI Pro and DXP HDMI Series • SIS Configuration and Control
X4# X4$
If = I, then:
(input 1 through input 8)
X4# X4$
If = F, then:
X4# X4$
If = P, then:
0 = no response
1 = fail or missing
2 = fixed or restored
3 = both 1 and 2
4 = suspend
1
0 = off (default), = on
01 through 99 (two ASCII characters)
38400
9600, 19200,
m
odd, even, none, ark, space (Only the first letter is
required. Default = none.)
7, 8 (default = 8)
1, 2 (default = 1)
0 = RS-232 (default)
1 = RS-422
0 = clear/none (default for Telnet connection)
1 = verbose mode (default for RS-232 or RS-422
connection)
2 = tagged responses for queries
3 = verbose mode and tagged for queries
).
1 = 10 seconds through 65000
(Default is
10 = 100 ms (default) through 32767
2 = 20 ms (default) through 32767
#L = Length of message to be received
#D = Delimiter value
# = byte count (1 through 32767)
0 = Use Send data string command
parameters
1 = Use Configure receive timeout command
parameters
Default: 25.255.0.0 (no padding)
0.0.0.0
= 0 (all inputs) or 1 through 8
= 00 (all fans)
= 00 (both power supplies)
, 115200 (Default = 9600.)
30
= 300 seconds = 5 minutes)
69