Extron electronics DXP DVI Pro User Manual page 16

HDMI series: Connect HDMI source devices to these female 19-pin type A HDMI
•
input connectors.
Pin Signal
1 TMDS data 2+ 7 TMDS data 0+ 13 CEC
2 TMDS data 2
shield
3 TMDS data 2– 9
4 TMDS data 1+ 10 TMDS clock+
5 TMDS data 1
shield
6 TMDS data 1– 12 TMDS clock–
Figure 6. HDMI Connector Pin Assignments
NOTE: LockIt cable lacing brackets, one for each HDMI input and output
connector, are provided with the DXP HDMI. These brackets can be used to
secure the HDMI cables to the DXP connectors to reduce stress on the HDMI
connectors and prevent signal loss due to loose cable connections.
For information on attaching the LockIt brackets, see the LockIt HDMI Lacing
Bracket Installation Guide card, available at www.extron.com.
Output connectors — (see
C
DVI Pro series: Connect DVI output devices to these female 29-pin DVI-I output
•
connectors.
HDMI series: Connect HDMI output devices to these female 19-pin type A HDMI
•
output connectors.
NOTE: The switchers do not alter the video signal in any way. The signal that is
output by the switcher is in the same format as the input signal.
Ethernet port — If desired, connect the DXP switcher to a computer or to an Ethernet
D
LAN via this RJ-45 connector. You can use a computer to control the networked
switcher with SIS commands from a remote location. You can also control the switcher
from a PC that is either running the Matrix Switchers Control Program or via the HTML
pages that are pre-loaded on the switcher (see
page).
Ethernet connection indicators — The Link and Act LEDs indicate the
status of the Ethernet connection. The green Link LED indicates that the
switcher is properly connected to an Ethernet LAN. This LED should light
steadily. The amber Act (Activity) LED indicates transmission of data
packets on the RJ-45 connector. This LED should flicker as the switcher communicates.
Reset/Power LED — This green LED remains lit while the DXP has power. It also
E
blinks the appropriate number of times when the unit is being reset, indicating the level
(mode) of reset that has been performed.
Reset button — This recessed button initiates four levels (modes) of reset on the DXP
F
switcher. To initiate the different reset levels, use a pointed object such as a small Philips
screwdriver or a stylus to press and hold the button while the switcher is running or
while it is being powered up (see
Pin
Pin Signal
8 TMDS data 0 14 Reserved
shield (NC on device)
TMDS data 0– 15 SCL
16 SDA
11 TMDS clock 17 DDC/CEC
shield ground
18 +5 V power
19 Hot plug
detect
figure 3 on page 6 and
Ethernet Connection
Resetting on page 40 for more information).
DXP DVI Pro and DXP HDMI Series • Installation
Signal
1 19
2 18
HDMI
Type A Connector
figure 4 on page 7)
on the next
8