Chapter 2 - Installation; Installing The Iec 62591 Module - Emerson IEC 62591 Instruction Manual

IEC 62591 Wireless Interface Instruction Manual (for ROC800-Series and FloBoss 107)

Chapter 2 - Installation

In This Chapter
Caution

2.1 Installing the IEC 62591 Module

ROC800 To install a module in the Series 2 ROC800:
Caution
Revised June-2018
2.1 Installing the IEC 62591 Module ...................................................... 2-1
2.2 Installing the Field Link .................................................................... 2-3
2.2.1 Optimizing the Location ........................................................ 2-3
2.2.2 Positioning the Antenna ....................................................... 2-4
2.2.3 Mounting the Field Link ........................................................ 2-4
2.2.4 Grounding the Field Link ...................................................... 2-5
2.3 Wiring the Module and Field Link .................................................... 2-5
2.3.1 Wiring the Field Link ............................................................. 2-5
2.3.2 Wiring the IEC 62591 Module to the Field Link .................... 2-6
2.4 Preparing for Configuration and Commissioning ............................. 2-7
This chapter describes installing the IEC 62591 module in either a
ROC800 or FB107, installing the Field Link, and connecting the Field
Link to the IEC 62591 Wireless Interface module.
: This chapter covers the physical installation process. To
Note
configure and commission the IEC 62591 Wireless Interface,
refer to Chapter 3, Configuring and Commissioning.
Module initialization can take up to five minutes. During this time,
module configuration is not possible and the USB port on the module
is not recognized. Attempting configuration before initialization is
complete may cause errors on your network. The module is initialized
when the Status field on the Network tab includes the word Online. If
network errors persist after module initialization, power cycle your
device and try again.
You install the IEC 62591 Wireless Interface module in a Series 2
ROC800 or FB107 as you would any other module. However, you can
install only one IEC 62591 module in either device.
If any processes require backup, arrange for that before removing
power from the device.
Remove power from the device.
1.
Remove the wire channel cover.
2.
: Leaving the wire channel cover in place can prevent the
Note
module from correctly connecting to the socket on the
backplane.
Perform one of the following:
3.
Installation 2-1